SIB Standalone Keypad Access Control Bedienungsanleitung

Standalone Keypad Access ControlUser ManualPlease read the manual carefully before use this unit

1011.2 Door SettingsRelay Output Delay TimeTo set door relay strike time0-99 is to set the door relay time 0-99 secondsDoor Open DetectionDoor Open To

1112.The unit operating as a Wiegand Output ReaderIn this mode the unit supports a Wiegand 26 bit output so the Wiegand data lines can beconnected to

12

21. Packing ListName Quantity RemarksKeypad 1User manual 1Screw driver 1Φ20mm×60mm,Special for keypadRubber plug 2Φ6mm×30 mm, used for fixingSelf tapp

3programming modeTo unlock the door for a PIN user Enter the then pressTo unlock the door for a card user Present the card3. DescriptionThe unit is si

45. SpecificationsOperating VoltageDC 12V±10%User Capacity 2000Card Reading Distance 3-6 cmActive Current＜60mAIdle Current 25±5 mALock Output Load Max

57. WiringColour Function DescriptionPink BELL_A Doorbell button one endPale blue BELL_B Doorbell button to the other endGreen D0 WG output D0White D1

6special power supply diagram:8. To Reset to Factory Defaulta. Disconnect power from the unitb. Press and hold # key whilst powering the unit back upc

7modeOpen the door - Bright - D iAlarm Bright - - Alarm11. Detailed Programming Guide11.1 User SettingsTo enter the programming mode999999 is the defa

8To add a card user (Method 2)This is the alternative way to enter cardsusing User ID Allocation. In this method aUser ID is allocated to a card. Only

9programming mode so the user canundertake this themselvesTo delete a Card and PIN user just deletethe cardTo add a card user in card mode ( )To Add a